Sounds

Rose Engine Butler is setup to make three sounds for certain conditions.

The Sounds and What Makes Them Happen

Sound	Sounds when	Does not sound when	Heard on
Fault siren one steady 3-second sound	The signal tower's red light comes on: an axis has a following error, a limit switch has tripped, or the Base Box or Expansion Box has lost contact.	E-Stop is pressed, the machine is turned off, or a program is stopped.	Signal tower buzzer, Monitor speaker (via HDMI), or Both
Done 3 short beeps	A Gcode program runs to its end. A Synchronized Movement (Run Operation) reaches its end point. A Cut Thread finishes all of its passes.	The operation is stopped part way, by Stop, E-Stop, turning the machine off, or an error. Return to Start does not beep.
Pause 2 short beeps	A Gcode program stops at an M0 or M1 and is waiting for you to continue it.	You press the Pause button yourself.

The use of sounds with Rose Engine Butler is setup on the Inputs, Outputs, and Sounds tab in the Rose Engine Butler Settings program.

spacer line

eMail comments to
ColvinTools @ Gmail [period] com -> mailto:ColvinTools [snail] Gmail [period] com